998C 4 IN 1 Remote Dog Training Vibra & Electric Shock Collar

Features

1. The strong static impulse can penetrate the hair of the pet and fabric within 6mm thick. It is unnecessary to let the discharging point touch the skin of the pet. Therefore it is safe for the pet.

2. The static impulse can quickly and effectively curb the improper deeds of the pet.

3. The warning vibration will let the pet associate the vibration with static impulse. In the end, vibration will achieve the same effect as the static impulse.

4. Both the static impulse and warning functions are set with automatic stop. This is for not reprimanding the pet continuously.

5. With the vibration induction power switch in the collar receiver, it will turn on and turn off automatically to save power.

6. Water resistant Collar

Specification Collar

Length: 43mm Height: 68mm Width: 38mm.
Weight 110 g (module + battery )
Collar length adjustable from 20 to 50cm
Power:2* 1.5V AAA battery (supplied)
Water resistant and shockproof.

Specification HandsetLength: 120mm Height: 25mm Width: 45mm.
Weight: 110g (with battery)
Power: 2*1.5V AAA battery (supplied)

LED signal light and illumination at night

The sound function for attracting attention
Water Resistant

User’s Manual of E-304/314 Remote Control Training Collar

（Vibration and Static Impulse）

I. Preparation Before Using

1. Check that battery is installed in the remote controller then switch it on.

2. Match the remote controller and the receiver. As soon as putting batteries into the receiver, you should press vibration or shock button on the remote controller and the receiver will vibrate twice. In this way the match is done and the remote control system can operate normally.

3. If the receiver vibrates on its own without pressing any button after batteries are installed, please take out the batteries for over ten seconds and put them back and try step 2 again.

4. Checking the remote controller: Press the buttons on the remote controller one by one, the indicator light will light. If the indicator light doesn’t light or goes dim, change the batteries.

5. Checking the receiver: With the vibration induction switch in it, the receiver will enter into standby mode automatically upon shaking. The receiver will turn off automatically when it is in stillness for more than 3 to 5 minutes, so as to save power.

6. Connect the collar and the receiver. Adjust the length of the collar so that it suits the neck of your pet best. Don’t make it too tight while the discharging point of the receiver can touch the neck of the pet.

7. Press the vibration button on the remote controller and the receiver will vibrate. In about three seconds, weak static impulse will be release and it will turn stronger gradually and will be stopped in 9 seconds.

8. Press the shock button on the remote controller and the discharging point will release static impulse. The discharging state can be checked by the testing light supplied separately in the box.

9. Press the whistle button on the remote controller and a sound will be made from the receiver.